What is the head bolt torque specs for a 1987 dodge ram 50 2.0?

Related Answers

Explore the latest questions and answers related to "What is the head bolt torque specs for a 1987 dodge ram 50 2.0?"

Answered: problems f-150 with 5.0 v8 engine

I have had no problems with my Ranger's 4.0 v6 engine. Would you like to narrow the issue down, or shall I wait for Madam Z to come back from visiting an old who's feeling down.

Answered: 5.0 mustang suspect contaminated fuel (no accident). How to confirm?

The only way to prove it is a chemical analysis.

Answered: What size socket do I need to remove the cylinder head bolts on a 2000

Don't you have any tools? Are you going to buy just the one? You will need more to get to the head bolts, just try what you have till it fits.

Answered: 1998 Dodge Ram 1500 electrical problems Lights ...

You will have to get a new fuse box. I just spend 1000.00 to find that out.

Answered: 2004 Dodge Ram 1500 overheated now won't idle”.

does it idle rough when you have your foot on the gas padle to keep it runing? this truck has aidli contral moter on the throttle bodyit may be not working ,coolent tempture sensor,gone out ,need to scan first to see for trouble codes,than come back , i also need more information about the over ...
Liked this question? Tell your friends about it

More Questions

How to get falt codes 07 dodge ram?

Multi-cardiag m8 1994 Through 1997 Models 1 Insert the key in the ignition and turn the ignition on and off quickly in this sequence: on, off, on, off, on. Don't crank the truck. If you crank the engine by mistake, begin the sequence again as the process will be aborted. 2 Observe ...

Why does the upper hose gets hot and the lower hose does not on a 1987

closed thermostat ,,closed radiator,,,water pump fail.

Torque specifications for a front wheel bearing on a 1967 chevelle

You can get that info on google, look for a manual.

I just put on new urathane body mount bushings on ...

I used to be a gm mechanic, any time we would replace such stuff an impact gun was always used to tighten them back up, so I dont thing you have to worry about overtightening them.