what does the code P1681 mean 2003 dodge neon?

Related Answers

Explore the latest questions and answers related to "what does the code P1681 mean 2003 dodge neon?"

Answered: Complaints with Dodge neon 2003 car stalls loses power engine light off

I had that going on for a while in an 05 SXT model Neon, but it only happened when it rained. It eventually quit doing it and I never did figure out what was causing it. I did however have my cam sensor replaced cause my check engine light went on a couple years after the stalling issue.

Answered: (April, 2008) My Dodge truck overheated after ...

You heather core the problem. To replace you got to remove all the dash and A/C core lots of work and dash will crack. If you can live without heat remove the water heater hoses engine side install a small copper 1/2 or 3/4 water pipe with clamp to the two hose good to go Replacement of heater ...

Answered: How does a clutch system work on a 2003 dodge neon

The fan blows when the CPU is warm.

Answered: What does to inibate mean to a person?

I think he meant intubate, but if he can't spell it I ain't telling him what it means.

Answered: Meaning of word assential

A hug is consequential If it's not consensual. The singular essential Is a word assentual.

Answered: Fog lights 2003 Dodge NEON

what is the question about your fog lights? is it defective or your getting a new one?
Liked this question? Tell your friends about it

More Questions

How to reset engine codes for a 1994 dodge?

Disconnect the negative cable to the battery for about a minute and see if the codes go away.

What does PSA mean

PSA (medical term) is a test for Prostate-Specific Antigen. A high number indicates probable prostate cancer. PSA (Airline) was Pacific Southwest Airlines, now part of US Airways. There's also another regional carrier named PSA, also part of US Airways.

Musculloskeletal medical coding

According to ICD-9-CM procedures of medical coding , the codes 810 to 819 are used to mention Fracture of the Upper limb or the Hand.

Auto repair

On most cars, you remove the cotter pin from the castle nut on the ball end of the tie rod, and remove the castle nut. I use a "pickle fork" to pop the pivot ball stud (it's a two prong fork that wedges between the ball and steering knuckle) but I have used a hammer and just beat the end where you ...