Electronic Ballast Wiring Diagram for 8 foot 2 lamp HO Fixture My new ballast has a 5 wire output 4 are red and one is yellow. The leads to the sockets. are two yellow from one end and two blue + two ...
-
Posted by Jeff 2 months ago
|
how to install replacement sensor for outdoor lamp
|
how interconnect 20 smoke detector in a residence if i can interconnect only 12
-
Posted by jose 10 months ago
|
Does the capacitor voltage rating matter for the actual motor voltage used. In other words, Does a 330vac 64-77uFd work correctly for a 115v AC motor calling for a 64-77uFd capacitor, or must you use ...
-
Posted by Dave 10 months ago
|
Can a contractor put a lein on your home if he is not paid
|
Newburyport ma. roughin electrical inspection what is expected
|
How do you wire split receptacles controlled by three way switches?
|
pm55l-048-hp07 wiring
-
Posted by Mike 6 months ago
|
What wire do I need to run a 100 amp service to a subpanel @ 100'?
|
How to hook up 12 volt light on a 110v gfci line
|
what is the electrical designation of a circle with a verticle line through it
|
i am removing an old baseboard heater and replacing it with a new 240v baseboard heater. the 2 supply wires coming from the wall are white and brown (plus a ground wire). does this indicate 120v or ...
|
I need to know how to wire a 4 pronged appliance into the breaker box
|
how do you wire a second fan without light coming from a ceiling with light kit
-
Posted by jody 2 years ago
|
I had some electrical work done and found out it is not up to code. Am I obligated to pay this bill?
-
Posted by Sassy 2 years ago
|
i have a 13-pin continental plug for my trailer.where do the wires go to convert to a 7-pin u.k plug?
|
I have a 200 VAC 3 phase Compressor. I have wired my White to T-3, Red wire to T-2, and Black wire to T-3. At my breaker panel I wired my White wire to ground, red wired to a 120 VAC breaker, and ...
|
|
|
I need a pull chain switch on a light that i purchased and i am direct wiring it into the ceiling. I hooked up the wires to be diverted into the pull chain switch, and turned on the power to see if it ...
-
Posted by Jan 2 years ago
|
I am getting a voltage drop in one leg of a 220v circuit in a direct burial cable. the reading is 80v on that leg. what causes might be attributing to this. does the cable need to be replaced?
|
|
|
