Originated From
AOL Search

How to fix maytag washer stuck in spin cycle

Liked this question? Tell your friends about it

Best Answer

Sounds like an internal switch or relay but unless you have knowledge of working on washers, you may have to call this guy.  He's waiting.

All Answers

If the water that pumps out of the machine goes back into the machine after the spin cycle, your washer may be siphoning the water from a laundry tub that has a slow drain, back into the washer. The usual remedy for this is to improve the draining of the laundry tub. (Is something stuck in the drain?) Also, check for these problems:

If the drain hose reaches more than about 4 inches into the laundry tub, cut off the excess.

If your drain hose is lower than the washer's cabinet, install an air gap/siphon break assembly.
 For details check out here

Love to Write For the Peoples.

Related Questions

Other people asked questions on similar topics, check out the answers they received:

Asked: Have a maytag top load washer. model#mavt236aww ...

have a maytag top load washer. model#mavt236aww.should agitator shaft be realy hard to turn?

Asked: Washer skips spin cycle

my maytag washer model#lat9706aam the waser skips the spin cycle unless pull or wiggle the knob

Asked: After replacing drive belt on maytag washer model ...

after replacing drive belt on maytag washer model mav7257aww, the tub stops very hard after spin cycle and with a clunk sound .

Ask a Question... We'll forward it to people who know

More Questions

Maytag front load moldy smell

Your washer maybe leaking water into the inner drum. First, you have to check for signs of leaks. You may need to call on a technician to fix the problem. Otherwise, run an empty water cycle and add a cup of white vinegar. This should temporarily solve the moldy smell problem. Source: http://www ...

Ge washer my washer stops during the cycle and i have to hit the start

Open up the washer so you can access the control. Spray some contact cleaner on it. If this advice is ludicrous, then post the model number of your washer.

When i try to open a file it reads (SOMETHING WENT WRONG AND WORD WAS

Either it is not a Word file, or it has been corrupted, or your Word software isn't working. You can try rebooting Windows; that might fix Word. And you can try starting Word without opening that file; that will tell you whether Word is functioning. But it may be the wrong type of file for ...

My washer stops during the cycle and i have to hit the start button

Get # and model from the label and go to this site - http://fixitnow.com/