Posted 2 years ago
Anonymous

how to wire duplex 115v receptacles from 230v source?

Related Answers

Explore the latest questions and answers related to "how to wire duplex 115v receptacles from 230v source?"
LindaRuth

Answered: Building a duplex garage?

No, I'm not building one either.
Lewie

Answered: Electrical wiring - split receptacle

A split receptacle is where you break the little tab between the two screws on the hot side of the receptacle, so you could either have two different circuits on one receptacle like you'll sometimes find in a kitchen, or to have one half always hot and the other half switched like where you might ...
charlie2911

Answered: Which uses the least electricity 115v or 230v air condition?

For the same amount of cooling, usually a 230v. would take less power.
Gene Smolin

Answered: Who do you call if a tree knocks down your power wire?

As the property owner, you must remove the offending tree or the power utility will do so for you -- at your expense.
dectech

Answered: I have a hot grond wire to an outside light what should i look for

You should look for an electrician to check it out !!!!!!
Kelsie

Answered: Where to buy 3 way plug adapter 115v 2ire to 3 wire

You can check techrentals for that, go to their Autralia sitemap for the list of available equipments.
Liked this question? Tell your friends about it

Featured Questions

What do you think about the mistakes made by CNN and New York Post during coverage Boston Marathon bombings?
In Media & Journalism

What do you think about the mistakes made by CNN and New York Post during coverage Boston Marathon bombings?

What do you think about Obama
In Politics

What do you think about Obama's jokes about himself at the White House Correspondents' dinner?

What do you think about the death of Karl Berry, Australian Field Hockey Player, from a snake bite?
In Hockey

What do you think about the death of Karl Berry, Australian Field Hockey Player, from a snake bite?

More Questions

Electronic Ballast Wiring Diagram for 8 foot 2 ...

Connect the yellow wires to the yellow wire, that's your common wire and connect 2 reds to the two blues and connect the other 2 reds to the reds. The diagram should be shown on your new ballast.

How to wire a dayton 1.5hp motor to run counter clock wise no diagram

Well on an dc motor all you have to do is change the polarity of the input voltage and on a ac single phase you’d switch the starter winding leads and in a ac 3 phase you’d switch one leg of the input power.

Is a duplex wall plug consider one or two fixture

A duplex outlet is considered one device. It has that name simply because it has two (2) ports to plug something into it. When doing a count for an inspection it counts as one device.

Raw Source

Thank you so much!! I am used to using a Mac and the HP is a lot different. Thank you again