how to repair broken engine starter bolt holes?

Related Answers

Explore the latest questions and answers related to "how to repair broken engine starter bolt holes?"

Answered: Flex holes fix

flex holes give you choices about where to put it

Answered: What engine has the same rear bolt pattern as a 1960's era Volvo 2.3L

What engine has the same rear bolt pattern as a 1960's Volvo 2.3L? Depending on application, that could be their rock crusher, which interchanges with Continental 227AV 100 HP Diesel. It is a durable little 3-cylinder and has few problems. Volvo also made a 2.3 L diesel used in refrigeration. It ...

Answered: How can I repair a broken garden hose?

If you take it to a large hardware store, they may be able to sell you a replacement connector that clamps on. If you have a hole 10 feet from the end of a 50 foot hose, you could wind up with a 40 foot hose. I did that once, and it was never quite right. My choice would be to buy a new hose.

Answered: Where is the starter on a 94 gmc pickup?

On the front, lower, right side of bellhousing

Answered: Broken glass platter - can it be repaired

Brenda- This can be repaired, but you will always be able to see the break. If you live i a place like New York, I would try to get up with some glass blowers and talk with them. They may know something that I do not. JayR

Answered: How many bolts bolt the transmission to the engine in a 2002 chevy s10

The bell housing has 7 bolts from 1977-2003. From 2004-2013, it has 7 bolts also but has a different pattern. If you have to, you can make an adapter plate from 1/4" hard aluminum plate. Just get the smooth T-3 plate, and back up the bolts with hard chrome inserts from Hurst. Never put steel ...
Liked this question? Tell your friends about it

More Questions

Honda gc160 small engine forum: Engine runs great ...

The remaining factor is igntion and-or timing. Honda has a difficulty in that some of their engines use electronic ignition instead of the tried and successful coil-and-magneto system in use on other small engines. I suggest that you replace the defective Honda powerplant with a more robust and ...

Engine swap

I would like to recommend you to ATECH Motors Solutions Ltd.

How to repair broken revolver grips?

Wooden grips can be glued back together, although I would replace any broken ones rather than try it. Plastic grips can also be glued, or, possibly heat welded. Neither of these repairs looks very good, and I'd also be a little bit leery of strength. Replace the grip(s) if at all possible.

How to repair a burned bottom chord in a roof truss

Contact a competent building contractor in your area. if you have had a fire, the chances are very bad that more than one truss was damaged. Also check the floor and sub-floor beneath where the fire started. If you have suffered a fire, then electrical and plumbing will have suffered also.