how to remove 1987 honda standard transmission?

Related Answers

Explore the latest questions and answers related to "how to remove 1987 honda standard transmission?"

Answered: We have a 1987 honda trx 250x atv that was given ...

through extensive internet searching I finally found out that you have to line up the two lines horizontally with the flat deck of the motor while at the same timethe cranck case in the plug hole has 3 marks on it as well and tdc is the middle mark on compression stroke those should both be visible ...

Answered: We changed the Transmission fluid in my 2005 S 80 ...

I cant understand what you have done? When you change transmission fluid you drop the transmission pan to drain and also change a small filter in there. Next you put on a new gasket and put the cover back. you refill back through transmission dipstick tube untill it reaches proper level (with engine ...

Answered: Jeep cherokee where is the slave cylinder located on my 1988 jeep

I'm not real great with cars but I'm guessing you can ask a mechanic without being charged. Good luck.

Answered: Gum swelling 2 weeks after Wisdom Tooth Removal?

WebMD examines common problems with the gums, including soreness, swelling, and bleeding. Learn possible causes and find remedies to help keep your ...

Answered: Honda gc160 small engine forum: Engine runs great ...

The remaining factor is igntion and-or timing. Honda has a difficulty in that some of their engines use electronic ignition instead of the tried and successful coil-and-magneto system in use on other small engines. I suggest that you replace the defective Honda powerplant with a more robust and ...

Answered: Middle school low stress quiet activity

Let 'em loose and give 'em a good snack in the school cafeteria. Put out the makings of foot long sandwiches and juice. I mean, treat the kids to a righteous old snack and that keeps 'em going the right way.
Liked this question? Tell your friends about it

More Questions

Remove comment's

Hi there: So I can better assist you, could you please provide me with additional information? Please let me know what area would you like your comments to be removed. Thank you.

Is there a difference in a 727 transmission for a 318 or 360 engine

You know, there might be a difference in the torque converter, but the trans housing mounts should be identical. Did you check converters at JC Whitney to see if they sell different types for different engines?

Locate transmission dipstick

there is no dip stick there is a plug on all manual trannys, find the plug ,should be on side, fill untill starts coming out, it will be full, just like a rearend...