how to build a stone and wood steps?

Related Answers

Explore the latest questions and answers related to "how to build a stone and wood steps?"

Answered: Where to buy a wood chipper machine ?

The wood chipper machine http://www.wood-chipper-machine.com Drum wood chipper is the special equipment to produce the wood chips which can be widely used in chipboard factory, middle and high density fiberboard factory, stubble factory, biomass power plant, and wood chipping factory. Raw ...

Answered: Why wood shavings is more preferred for animal bedding ?

Because 1) wood shavings with good absorbency properties ,they will absorb the moisture/water quickly,especially animal's urine,healthy 2)Poultry pens and livestock stalls is easy and economic for cleaning ,the shavings can be reused. 3) The shavings is soft,comfortable as bedding 4)Shavings are ...

Answered: How to Wire a Steel Buildings?

A steel building is a metal structure fabricated with steel for the internal and commonly ,but not exclusively for exterior cladding Such buildings are used for a variety of purposes including storage, office space and living space.

Answered: Cutting the stones (opal)

Opals aren't cut, they're ground and polished. But yes, if there is someone in your area that cuts, grinds and polished gemstones, you can certainly pay them to prepare the opals. If there's a good rock shop in your area, ask them to recommend someone. Or they may provide that service themselves.

Answered: Wood stove draft problem

If it's installed correctly, the draft fan should solve your draft problem. The very best ones I've seen are have two speeds. The fan runs at very low RPM to give just enough airflow to keep your fire going and the combustion gas going up the chimney. When there is a call for more heat, the fan ...
Liked this question? Tell your friends about it

Be The First To Answer

Other people asked questions on various topics, and are still waiting for answer. Would be great if you can take a sec and answer them

More Questions

Putting wood over steps

thank you. everyone has been most kind to answer

What do you do when the polyurethane gets peeled ...

Hello, lightly the sand the areas with a 220 grit sandpaper to remove/feather out the edges where the poly came off, match the finish sheen and brush it on, remember two to three light coats are better than one heavy coat.

Greasy varnished paneling

Try Dawn dish detergent with some very fine (I stress the word very fine) steel wool. Be sure to rub in the direction of the grain of the wood. You might try Dawn alone first but if it is really caked on steel wool might be needed at which point when you are through you will need to apply ...

Re-sawing wood becomes unusable

My question was, Re-sawing exotic wood becomes unusable because it curls up while it drying. Answer, After re-sawing your wood you would lay out cross peices of wood between the layers of wood so air can move between all boards and by putting weight on top to keep them flat UNTIL the wood has dried ...