how many outlets can be run on a 20 amp breaker with 12 gauge wire.?

Related Answers

Explore the latest questions and answers related to "how many outlets can be run on a 20 amp breaker with 12 gauge wire.?"

Answered: How many wall outlets could be conected to a 20 ...

In NZ when working out what size breaker to use for an outlet circuit we allow for 8-10 amps per outlet, and for 75% of these to be used on full load. Based on this I would probably reccomend 3 to 4 max, outlets for that size circuit breaker. Obviously if you were using low drain appliances it would ...

Answered: How many amps is the Burr King Model 960 220 volt Belt Grinder Rated

The motor for this model is rated at 1.5 HP. Using a power factor of 1, this translates into a little over 5A.

Answered: What size wire for 4000 wats

amperage = watts/voltage I = P/E I = 4000/120 I = 33.33 amps If the 4000 watts is one device, I would use 10G JayR

Answered: Locking devices on old 220 circuit breakers

That breaker is the worst breaker I everheard. You mean it cannot be tripped. If something going wrong with your electrical circuit then you cannot stop it because your breaker has been locked. Replacement would be the solution and for safety.

Answered: How old is the 12 gauge 3.5" magnum?

It was introduced in 1988, Mossberg made the first shotgun with 3 1/2 inch chambers, Federal made the first shells to fit it. Short answer is about 26 years.
Liked this question? Tell your friends about it

More Questions

Ss wire mesh

how to buy high quality stainless steel wire mesh

Problem with circuit breaker

I take it the breaker works, but your fingers are the problem. If you want to, you can replace it with another breaker. Try out the replacement before you buy it, to make sure it flips easily enough. A quick easy solution may be to use something to pry the switch lever with to flip it. Or loop a ...

Residential home......accident caused circuit to go "dead" without

You might have a ground fault interrupter (GFI) that tripped at the socket. But more likely the short circuit melted the wires between the breaker and the 5 outlets. You need an electrician to replace the damaged wires.

What is the best way to run the power wire throw the fire wall in a 2000

When running through a firewall your most important issue is to avoid knicing or cutting the insulation - that means good cut resistant leadwire and a grommet around the access hole oyu are using. Normally there are a host of firewall holes with rubber or plastic inserts (grommets or sorts) that you ...