how do I transfer model boat plans to the wood for precise cutting?

Related Answers

Explore the latest questions and answers related to "how do I transfer model boat plans to the wood for precise cutting?"

Answered: Visby class corvette model boat plans

Looking for Plans for the VISBY Model Boat.....any size.....Thank you Marc marc17mach4@aol.com

Answered: Where to buy a wood chipper machine ?

The wood chipper machine http://www.wood-chipper-machine.com Drum wood chipper is the special equipment to produce the wood chips which can be widely used in chipboard factory, middle and high density fiberboard factory, stubble factory, biomass power plant, and wood chipping factory. Raw ...

Answered: What kind of finish can I put on light raw wood without turning it

Polyurethane. Go to Home Depot and ask the same question - they will point you towards products that do exactly what you want.

Answered: Cutting the stones (opal)

Opals aren't cut, they're ground and polished. But yes, if there is someone in your area that cuts, grinds and polished gemstones, you can certainly pay them to prepare the opals. If there's a good rock shop in your area, ask them to recommend someone. Or they may provide that service themselves.

Answered: Why wood shavings is more preferred for animal bedding ?

Because 1) wood shavings with good absorbency properties ,they will absorb the moisture/water quickly,especially animal's urine,healthy 2)Poultry pens and livestock stalls is easy and economic for cleaning ,the shavings can be reused. 3) The shavings is soft,comfortable as bedding 4)Shavings are ...

Answered: Wood boat refinishing

Hello, I have tried to post 3 times to ans. your ?. Hope 4 is the charm! There are @ methods to look at! 1( COMPLETELY remove the old chinking, and caulk w/ a 4" right angle grinder, using a diamond edge TILE cutting wheel. The blade will last, and if you are carefull will NOT damage the wood ...
Liked this question? Tell your friends about it

More Questions

How Can I Cut a Circular Hole in Wood of Nearly 10 inches?

That isn't difficult. Inside-diameter cuts. Set up a router with the desired profile bit, and use a plywood template to set the diameter (or any chosen shape) of ID cut. Outside-diameter cuts. Agan using a template, set up the shape you intend to cut and set the template to accommodate the edge ...

Boat half models from Bequia

What is your question?

I have a 4hp motor on a 12 ft. v-hull boat. The ...

A "whaletail" helps, no question about it. A 4hp motor is a little on the small side to get your boat up on the step. You can adjust the tilt of the motor so the prop is further toward the front of the boat . That will put a slight downward pressure to the front. Another thing you can do is put ...

Wood modeling

I have been working with wood and did a little modeling; I think that these two sites might help you. The first have a list of woods, the second is more serious: if you really want to be sure about the type of wood it has a density index. http://www.modelshipbuilder.com/resources/wood-used-in-model ...