Member Since June 18, 2009
Liked this profile? Tell your friends about it

Recent Activity by warpig

Answered: Car just stopped running

i would check the battery terminals make sure they're tight and no corrosion . also check the charging system. check the grounds too. test the battery it should be close to 13 volts. the alternator ...

Answered: RPM's drop with A/C on

the a/c compressor could be starting to seize up . check the charging system . could be putting a load on it and the alternator is weak.

Answered: Acura CL 2.2 pushes water under dashboard when AC ...

there should be a drain that comes out of the firewall in the engine compartment sometimes they clog up with leaves,pineniddles,acorns,etc.. it looks like a piece of rubber tubing that just hangs ...

Answered: 1998 honda dx check engine light on

could be the 02 sensor . but the map sensor , the coolant temp sensor or the maf sensor will also do it.

Answered: We change our oil regurlarly and just had ...

usually if the check engine light comes on and there is no difference in the way the vehicle is running it usually an 02 sensor . they will cause a check eng light to come on and go off and come on ...

Answered: Car won't start

not the crank sensor. check battery terminals for corrosion or looseness. check battery voltage should be close to 13volts. if that's good. try having someone turn the key to the start position and ...

Answered: Desperatley need advice from qualified mechanic ...

the over heating may have seized the pistons in the motor.

Answered: 1993 Chevy k1500 5.7l efi 350 no start

try the idle air control (iac) if that is stuck then that would cause it to act like that when everything else seems alright. or the crank sensor is bad.if you have a tachometer on it see if moves ...

Answered: 99 chevy pu starts but won't move.

sounds like the fuel filter is clogged or the fuel pump is weak.

Answered: 89 geo spectrum won't start. gettig fire to the ...

try checking the plug wires with a spark tester. if it,s not that then i would replace the ignition module. hope that helps.

Topics of Interest

Contacts

warpig has no contacts.

Compliments

No compliments were posted on warpig's profile yet.