Member Since October 20, 2008
Ask

Recent Activity by Ron

Show:

Answered: I have a ford f150 xlt triton v8 it is a2000 ...

check the emergency brake shoes. Had the same problem and one of the springs had broken. You have to pull the rotor to get to them. Hope this helps

Answered: How to install an electrical outlet box

This might be tough if you have no knowledge of this. Easy to do, attach a plug to the light and run it to the nearest recpitical. If you need the box in the wall, you will need power. decide where ...

Answered: I'm replacing a light fixture and get the black ...

The red wire is for another switch. treat it the same as the black wire. You [should] have two switches in the box that turns on the light. It is used for a fan light combo, to turn on the light and ...

Answered: GFIC Outlets not functioning

Yes they do go bad. When replacing check to see if 15 or 20 amp circit. You will know by the breaker size. Do not mix up the wires when replacing. One set is the feed and the other is supply to other ...

Answered: I have a ram 1500 97 that has a new engine ...

Not sure about what you mean gets spark but no fire. How far is the spark getting? If it is making it to the plugs, check your timing. pull number 1 plug get it TDC comp. and see where you rotor is ...

Answered: How to free a sticky valve on a 5.0 mustang.

if it has a carb, trickle some trans fluid down the carb, Marvel Mystery Oil works well also. Kepp the engine running with this, you will get a lot of smoke!! Kepp it running at a high rev to burn all ...

Answered: Parts

check these people, under81com@yahoo.com for used parts, also might try paddock, yearone, even jegs for new ones, someone should have those parts. good luck

Answered: Removing ball joints 2001 ford f150 pickup lower ...

Be sure you gat a spring compressor, that will fly out and take your head off!!Very dangerous, You will need a pickle fork/ball joint seperator, AFTER the spring is compressed, take the castle nut ...

Answered: Is there any help to increase gas milage 0n an 99 ...

I have the same truck, got around 14 when I started, up to around 24 no. installed a K&N filter system, and true dual exhaust with flowmasters. also run Castrol Syntec motor oil. Do not know that will ...

Activity Summary

Topics of Interest

Contacts

Ron has no contacts.

Compliments

No compliments were posted on Ron's profile yet.