Member Since September 17, 2008
Ask
Liked this profile? Tell your friends about it

Recent Activity by magnumrapala

Answered: 2003 250hp mercury outboard alarm warning ...

if its a 2-stroke the alarm and RPM reduction together would be triggered by overheating or the oil system telling the engine there is no oil

Answered: How to replace the tilt and trim motor on a ...

Yes, looking at the motor from the back there is a slot on the left which has a flat head screw in it, this is the manual relief valve turn it to the left until you can lift it. Make sure once the ...

Answered: I have a evinrude motor with a serial # of 15012 ...

cant tell by that you need the model number, it will read someathing like E90TLERS What you look at are the 2 letters E and R This number would be a 94 decode with INTRODUCES. I=1, N=2, T=3 and so on ...

Answered: Have a 16 ft Alunacraft with a 40hp tiller for a ...

the first answer is correct. I do think that the boat will float with a 70 on it but honestly with an aluminum boat i would not suggest it because the bottom of the hull is not designed to be a fast ...

Answered: How fast can i get my 13 foot 1991 sos express ...

depending on the hull design and weight of the boat i wouldn't expect more than the low 60's

Answered: I Have a 17' Larson with a 88 spl johnson on ...

If you are turning 5000 rpms at WOT the prop size should be fine, try a fixed hub prop. The motor should be turning between 5k and 5500 at WOT with a load. You can try a 13 1/2 x15 and that may help a ...

Answered: I have a 25 hp mercury 2 cycle outboard motor. I ...

50:1 (1 pint of oil for every 6 gallons of gas)

Answered: Steering for Yamaha 115 four stroke 2002 model on ...

hydrolic steering is an option for any outoard with a steering tube, if you have hydrolic steering there will be 2 hoses hooked up to a cyl that moves on a shaft to move the motor. if there is air in ...

Answered: We were putting new water pump parts on a 94 ...

it depends on what kind of motor it is, If it is an evinrude or johnson the shift shaft may have turned when you had the lower unit off. I would suggest taking the foot back off and making sure that ...

Answered: How to hook up a 12-24 volt system for boat im ...

you have batt 1 and batt 2, take a wire and connect the ground from batt 1 to the pos of batt two. take another wire and connect the pos from batt 1 to the ground of batt two and there is a 24 volt ...

Activity Summary

Topics of Interest

Contacts

Ashley
Ashley

Compliments

No compliments were posted on magnumrapala's profile yet.