Member Since November 25, 2008
Ask
Liked this profile? Tell your friends about it

Recent Activity by Greg

Asked: Fiberglass bathtub installation

What do I use for fiberglass bathtub bedding material ? To fill the gap between the bottom of the tub and floor ...And any tips as to aforementioned install ...
  • Posted 2 years ago

Answered: Washing machine drainpipe leak

It sounds like you have a pretty major blockage/buildup somewhere in your drain line .... I would try using an auger type drain snake .. I wouldn`t use anything electric -manual only .. What type of ...

Answered: Leaking pipes under sink

Or the cheap route would be to put a bucket or pan under the drip....

Answered: Hot water heater problem

Are you sure your water heater is the leak source? It shouldn`t be wet under the catch pan !!!Your washing machine lines aren`t leaking or the drain from the washer , is it ?..... Can you feel any ...

Answered: Hot water heater problem

Is there a catch pan under the heater ? Can you tell where the water is coming from ? It`s not wet on top anywhere is it ?What temperature is the heater set at ?Perhaps it`s "boiling " ... 125 degrees ...

Answered: I have a toilet that screeches like a ...

I think you need a new fill valve ... They`re about $8.00 at any home improvement store ... Relatively easy to replace and takes 15 or 20 minutes on average to do , if you are mechanically inclined ...

Answered: Fix a leak in the bathroom sink, I tighted the ...

Sharon , Did you get your leak stopped ? How old is the faucet ? Greg

Answered: Hot water heater problem

It sounds like you had the pressure releif valve replaced by the plumber and my guess is that your tank itself is leaking now....is this an electric or gas fired water heater ? My guess is it`s time ...

Answered: Stain - Water mineral stain removal

Gil , You might try "Iron Out" w/ a soft scour pad or perhaps a "Mr. Clean Magic Eraser " .... The stain is in the enamel paint (assuming you have a cast iron Tub ..?)I`m afraid the best you will do ...

Asked: Older parts needed

playground equipment; I`m looking for some approximately 1" aluminum(?) / galvinized sleeves 11" long w/nuts set in the ends and pan head allen bolts to secure a double stack of 4 x 6`s .... It`s and ...
  • Posted 3 years ago

Activity Summary

Topics of Interest

Contacts

Greg has no contacts.

Compliments

No compliments were posted on Greg's profile yet.