Member Since September 12, 2008
Liked this profile? Tell your friends about it

Recent Activity by BG

Commented: About 4368486's answer

Are your ducts metal,l if so are they insulated? Is it a modern duct system? If it an older metal system, I have seen them with as much as a 60% loss in leakage. Get it evaluated before you take the ...

Answered: Air condition problem

When the aironditioner is running is it working properly? Is it a heat pump? Was this a new installation or an equipment change out? If it is an equipment change out, did the installer put the same ...

Answered: Filter replacement

I recommend a 40% pletted filter. A very important thing is the fit of the filter in the return. It needs to fit in the filter rack or grille so that its large enough to not allow any air to bypass ...

Answered: Using existing furnace ductwork for AC?

Generally speaking if the existing ductwork is thermally insulated, I would say yes. Are the existing ducts wrapped metal with wall or floor outlets? Are the ducts in a crawl space or in the attic ...

Answered: Central ac cooling problem

Did you replace your old unit with a like unit?

Answered: Free heat

Where do you live and do you have access to any water source, river, stream, pond, etc.

Answered: Boom under house with A/C

Could be that your duct system is metal and when cold air pass thru it it contracts leaving a concave area some where in the duct system, then when it cycles off it expands but leaving the concave ...

Answered: My evaporator is freezing up. i changed the filter ...

How old is the system? When did you last have it serviced? It could be low on refrigerant, if the system is several years old and you haven't been using a good filter, the evaporator (cooling coil ...

Answered: Heat pump insulation?

Sorry about the confusing physics answer. The large line always carrys gas! In the cool mode it sweats because subcooled gas is returning to the compresser from the cooling coil thats why it needs ...

Answered: Your Experience with a Goodman Heat/ac

A high percentage of bad equipment reviews are due to the installer with the remainder of bad reviews due to the end user not maintaining the equipment properly. If I were you I would be more ...

Contacts

BG has no contacts.

Compliments

No compliments were posted on BG's profile yet.