MAIL
You might also like:
Autoblog,
Autoblog Green,
and More
More Links
AOL Weather
DailyFinance
Engadget
FanHouse
JSYK
AOL Television
Philanthropy
Switched
WalletPop
PopEater
Asylum
MovieFone
You aren't signed in
Sign In
Main
Ask
Sign Up
Explore
More
Richard
Send a private message
Member Since August 31, 2008
Ask
Ask
Liked this profile? Tell your friends about it
Facebook
Windows Live
Yahoo
Twitter
Digg
Google
del.icio.us
Reddit
Link
Embed
Copy and paste the text above to share this Q&A
Recent Activity by Richard
All
My Answers (13)
My Questions (0)
My Comments (0)
I am Watching (0)
I was Asked (0)
Answered:
Hole in wall
a picture is worth a thousand words. http://www.youtube.com/watch?v=MBotI2-CgkI
Posted 3 years ago
Answered:
Hole in wall
Go buy some drywall mud or spacking compound and a 4" tape knife. Or borrow from a neighbor. What you do depends on the size of the hole, and the type of wall. Assuming you have sheetrock and not ...
Posted 3 years ago
Answered:
Because of different wall thicknesses between type ...
FYI, copper pipe and copper tubing both are controlled at the OD. Ditto with steel pipe and tubing. Tubing OD (e.g., 0.25") is the same as nominal size (1/4"). That's not true with pipe, where the iD ...
Posted 3 years ago
Answered:
I checked an outlet with a three prong (three ...
Wires are probably crossed. The outlet didn't fail. That isn't a failure mode of an outlet. Shut off the breaker to the outlet. Remove it from the wall and check the wires. White wire (neutral) should ...
Posted 3 years ago
Answered:
There is a lot of noise coming from the tank of ...
I would check that the float is set to shut off below the level of the standpipe. Also make sure the flush valve isn't leaking. Sounds like the water is running all the time and the fill valve isn't ...
Posted 3 years ago
Answered:
When a faucet drain just won't stop leaking
I think you're talking about a leak whether the drain assemby interfaces to the bottom of the sink. I've had those leak before, so I wrapped teflon tape around the threads underneath the big washer ...
Posted 3 years ago
Answered:
Conventional hot water radiator hisses & spits ...
You get good answers when you ask good questions.... The obvious answer is this case is, you have a leak. Duh, right? Try being specific.
Posted 3 years ago
Answered:
Pedestal sink drain installation.
Are you going to run a vent line in the wall behind the new sink? If you do, the sink will be properly vented. If all you do is connect the sink p-trap to the shower line without a sink vent, then ...
Posted 3 years ago
Answered:
Water Shut off valve turns but doesn't turn off ...
The valve may have deposits in it that keep it from closing all the way, or (more likely) the washer inside the valve seat has deteriorated. Try opening and closing the valve a few times while the ...
Posted 3 years ago
Answered:
Best way to direct rain water from a house ...
You need to much more specific to get a meaningful answer. Is the problem storm runoff or downspout water or both? Is there a low spot filling up close to a foundation? Is there a lower area where the ...
Posted 3 years ago
1
2
Next
Subscribe to "Richard's Activity on AOL Answers"
Activity Summary
Last 7 Days Activity
All Time Activity
Questions
Answers
Helpful
First to Answer
Comments
0
0
0
0
0
0
13
0
5
0
Topics of Interest
Richard did not provide topics yet.
Contacts
Richard has no contacts.
Compliments
Richard will review your compliment before it's published for everyone to see.
* Please avoid HTML or links
Take a sec and thank Richard for helping
No compliments were posted on Richard's profile yet.
About
Feedback
Terms of Use
Privacy Policy
Copyright 2012 Yedda Inc an AOL Company and respective copyright owners
Member Since #since#
Last 7 Days Activity
All Time Activity
Questions
Answers
Helpful
First to Answer
Comments
More