Member Since April 30, 2009 , From Heflin, United States
Ask
Liked this profile? Tell your friends about it

Recent Activity by Kaiser Willy

Answered: Jeep running hot

You sound like you have a blown head gasket. Do a compression test on each of the cylinders and if any cylinder has a drop of 10 - 15 % more than the other cylinders then you have a blown head gasket ...

Answered: 98 escort zx2 swap engines and have no fire to ...

Is the ECM sending a signal to the coil. Check input line on coil for appropriate voltage (see manual). Also if the camshaft position sensor (typically inside the distributor is broken or misaligned ...

Commented: About ed's answer

It is possible that it is the fuses but it would have to be three different fuses because all those systems are independent of each other. Otherwise if you blew out a fuse on your blinker system it ...

Answered: No coolant flow to the heater core?

If the vehicle is not overheating the waterpump is fine. You can check it further if you were to crank it with it cold with the radiator cap off and watch it until the thermostat opened up (around ...

Answered: Dash Board Controls

I would purchase a service manual (NOT Haynes) and look at the wiring schematic for all of the affected components. When you find the are where all three lines are in a single component (such as a ...

Answered: Removal of a crushed top on a 2000 Ford ranger

If you have access to a port-0-power you may be able to SLOWLY unsmash the damaged areas. But that is a MAJOR pain and requires significant finese. If It were my vehicle I would go to a salvage yard ...

Answered: 1999 Acura Power Steering Pump

Check the rack and pinion for leakage around where the lines go into the rack and pinion. You state that you replaced the vacuum (suction) line. If it only leaks when driven that would mean that it is ...

Answered: My radiator bypass hose is leaking and I can't ...

If you can't find a hose what I have done before is when a hose has to make a sharp turn like many by-pass hoses where a preformed hose is called for and is much more expensive, I purchase the ...

Answered: Have a roaring noise in front end on the right ...

It is most likely one of two things . Either the CV axle has a bad bearing and is causing the noise or what I think is more likely and the bearing in the knuckle assembly is going bad. Generally these ...

Answered: Transmission problem 2001 ranger

Very detailed answer from previous responder. Sounds like a winner but more briefly there are a couple of things that could cause it if the transmission is an A4LD which is a 3 speed automatic with ...

Activity Summary

Topics of Interest

Contacts

Kaiser Willy has no contacts.

Compliments

happycaption says:
"I think you are right... there are ALOT of underlying issues to my depression and anxiety- remembering and focusing on this one indescresion, one in which I meant no harm and am far too hard on myself over, was the straw that broke the camel's back I think. Exploring my issues in therapy has been benifical and I am going to start on some anti-depression meds as well... hopefully this will help me move along with my life."